Canon EOS 300 D - Manual (Page 126)

Troubleshooting Guides_________
If there is a problem, first refer to this Troubleshooting Guide.
Power Source
“The battery cannot be recharged.”
• You are using the wrong battery.
► Use Battery Pack BP-511 or BP-512.
O The battery is not properly attached to the charger.
► Attach the battery properly to the charger. (p.18)
“The camera does not operate even when the Power switch is set
to<ON>.”
.j The battery is exhausted.
► Change the battery pack. (p.18)
©The battery is not installed properly.
► Install the battery properly. (p.20)
© Battery compartment cover is not closed.
► Close the battery compartment cover tightly. (p.20)
G CF card slot cover is not closed.
k Load the CF card firmly until the CF card eject button pops out, then close
the CF card slot cover tightly, (p.24)
“The access lamp still blinks even when the Power switch is set to
<OFF>.”
O If you set the Power switch to <OFF> right after shooting, the access
lamp will still blink for a few seconds while the image is recorded onto
the CF card.
► When the camera finishes recording the image to the CF card, the access
lamp will stop blinking and the power will turn off.
“The battery becomes exhausted quickly.”
• The battery is not fully charged.
► Recharge the battery fully, (p.18)
OThe battery’s service life has expired.
k Replace the battery with a new one.
“The camera turns off by itself.”
• Auto power off is in effect.
► Set the Power switch to <0N> again or set auto power off to [Off]. (p.30)
“Only the <d]> icon is displayed on the LCD panel.”
©The battery has almost exhausted.
► Recharge the battery, (p.18)
124