Canon IXUS Z65 - Manual (Page 43)

Specifying the Print Quantity
Changing the Print Quantity After Taking a Shot
Seiect the mode for
specifying the print quantity
for the previous frame.
• Press the Q button ® and
then press the SELECT button
(D for at least 2 seconds
^ "P-0” (no prints) blinks on
the LCD panel
p r ? -
1
DATE
¥
5
£^a I
t
o
Set the print quantity.
• Press the button
• Each lime you press the
button, the setting changes
sequentially from P-1, to P-2,
through to P-9 and then back
to P-0, P-1, etc
• Hold the button down for 2
seconds or more to cycle
continuously through the settings.
Complete the setting.
• Press the SET button
^ The film rewinds 1 frame and
the print quantity specification
lor the previous frame Is
replaced
• The date/time display reappears
• If you switch the camera off before completing the
setting, the setting reverts to its previous value.
• If you replace the battery, the date and time display
on the LCD panel reverts to three blinking dashes
(“.......... ") and you cannot specify the print quantity.
When this occurs, set the date and time before
specifying the print quantity. 38)
■ Some photo shops may not support the print quantity
specification function. Check with the photo shop
beforehand,
0-43