CLIFFORD 420.4X - Manual (Page 17)

14 © 2011 Directed Electronics. All rights reserved.
Remote Control Configuration
The remote controls have operations that can be configured to a user’s
personal preferences. The following instruction will direct you through
the available configuration and programing options for the remote
control.
Remote Programming
Enter programming, press and hold the button for 8 seconds, the
transmit LED turns on to indicate the Main Menu is accessed.
Exit programming or go back to a previous menu, press and release
the
button. 1 short and 1 long beep is emitted for each step back.
When programming is exited the transmit LED turns off.
Remote Pairing
Remote pairing is a process where the remote, and the in-vehicle sys-
tem learn the other’s encrypted identification, securing communication
between the two from intruders.
The following instruction will step you through the remote pairing op-
eration.
Prepare the vehicle system for pairing:
1. Turn the key to the ON position.
2. Within 5 seconds press and release 1 time the Control button on
the Control Center.
3. Within 5 seconds, press and hold the Control button. The status
LED will flash one time and the horn (if connected) honks once to
confirm the system is ready for remote pairing.
4. Release the Control button and proceed to next step.
Pairing will exit if:
s
Step 7 is not completed within 60 seconds
s The doors are closed
s The ignition is turned off.