CASO Germany FonDue Set (2280, 2282) - Manual (Page 33)

caso Vario Power 3400 33
11.3.3 Danger of Explosion
WARNING
Incorrect use of the appliance incurs a danger of explosion due to the overpressure
produced.
Adhere to the following safety instructions in order to prevent a danger of explosion:
► Never heat food or liquids in sealed containers such as, for example, cans. The
container can burst due to the overpressure generated. A can is best heated by opening
it an placing it in a pot filled with a little water.
11.3.4 Danger of Fire
WARNING
There is a risk of fire if the appliance is used incorrectly.
Adhere to the following safety instructions in order to avoid a risk of fire:
► During operation remove all easily inflammable items (e.g. detergents, aerosol cans,
oven, cloths and dishcloths, etc.) from the immediate vicinity of the appliance.
Please note
If a fire should occur on the cooking hob, proceed as follows:

Switch the appliance off (if necessary, unplug the mains plug from the
socket or switch off the fuse)
 Smother the flames with a large pot lid, plate or a moist dish cloth.
NEVER EXTINGUISH WITH WATER!

After the fire has been extinguished allow cooking utensils and the
appliance to cool down and ensure that there is a sufficient flow of fresh air.
11.3.5 Dangers due to electrical power
Danger
Mortal danger due to electrical power!
Mortal danger exists when coming into contact with live wires or subassemblies!
Observe the following safety notices to avoid dangers due to electrical power:
► If the connection lead is damaged, you will need to have a special connection lead
installed by an authorized electrician.
► Do not operate this device if its power cable or plug is damaged, if it does not work
properly or if it is damaged or has been dropped. If the power cable is damaged, it will
need to be replaced by the manufacturer or his service agency or a similar qualified
person, to avoid any dangers.
► Do not open the housing on the device under any circumstances. There is a danger of
an electrical shock if live connections are touched and the electrical or mechanical
structure is altered. In addition, functional faults on the device can also occur.