3 unpacking, 4 disposal of the packaging, 5 setup – CASO Germany MCDG 25 master User Manual

Page 48: 1 setup location requirements

Advertising
background image

caso MCDG 25 Master (black)

48

11.3 Unpacking

To unpack the device, proceed as follows:

Remove the device out of the carton and remove the packaging material.

Open the door of the device and remove the internal protective film from the door.

Remove the accessories located in the cooking chamber and remove the packaging
material.

Remove the red coloured safety adhesive strip on the floor of the cooking chamber.

Do not remove the film on the oven ventilation opening!

Remove the blue protective film on the device itself.

Please note

► Only remove the blue protective film shortly before setting up the device in the location

where it will be used, to prevent scratches and dirt accumulations.

11.4 Disposal of the packaging

The packaging protects the device against damages during transit. The packaging
materials are selected in accordance with environmentally compatible and recycling-
related points of view and can therefore be recycled.

Returning the packaging back to the material loop saves raw materials and reduces the
quantities of accumulated waste. Take any packaging materials that are no longer required
to “Green Dot” recycling collection points for disposal.

Please note

► If possible, keep the original packaging for the device for the duration of the guarantee

period of the device, in order that the device can be re-packaged properly in the event
of a guarantee claim.

11.5 Setup

11.5.1

Setup location requirements:

In order to ensure the safe and trouble-free operation of the device, the setup location
must fulfil the following prerequisites:

The device must be set up on a firm, flat, horizontal and heat-resistant surface with
sufficient load-bearing capacity for the oven and the maximum weight of the expected
food that is to be prepared in the oven.

Choose the setup location in such a way that children cannot reach any hot surfaces on
the device.

The device is not intended to be installed in a wall or a built-in cupboard.

Do not set up the device in a hot, wet or extremely damp environment or near
flammable material.

Advertising