CASO Germany MCDG 25 master - Manual (Page 49)

caso MCDG 25 Master (black) 49
•
The device requires an adequate flow of air in order to operate correctly. Leave a
clearance of 20 cm above the oven, 10 cm around the back and 5 cm on both sides.
•
Do not cover up any openings on the device and do not block these off.
•
Do not remove the device’s adjustable feet.
•
The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
•
The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they
guarantee the prerequisites for the safe use of this device.
11.5.2 Avoiding radio interference
The device can cause the occurrence of interference in radios, televisions or similar
devices.
Such faults can be rectified or reduced as a result of employing the following measures:
•
Clean the door and the sealing surfaces of the device.
•
Set the radio, the television, etc as far as possible away from the device.
•
Connect the device to a different electrical outlet, so that various power circuits are used
for the device and the receiver with the interference.
•
Use a properly installed antenna for the receiver, to ensure good reception.
11.6 Assembling the accessories
Please note
► The device can be operated with the turntable or the grill rack.
► Use the grill rack only when the grill is in operation.
► The turntable can also be used for microwave cooking.
11.6.1 Turntable
Assemble the Turntable as follows:
•
Insert the turntable so the groove on the underneath side of the turntable catch in the
drive shaft.
11.6.2 Grill rack
•
Insert the grill rack onto the turntable.