Care and cleaning – Catler JE 4010 User Manual

Page 14

Advertising
background image

CARE AND CLEANING

12

CARE AND CLEANING

Ensure the JE 4010 Juice Extractor is turned
off by pressing the ‘On/Off ’ button on
the control panel to ‘Off ’. Then switch the
appliance off at the power outlet and unplug
the cord.
Ensure the JE 4010 Juice Extractor is correctly
disassembled. Refer to Disassembling your JE
4010 Juice Extractor (page 11).

For easier cleaning:
Clean as you go and avoid dried on juice or
pulp residue.
Immediately after each use, rinse removable
parts in hot water to remove wet pulp. Allow
parts to air dry.
To minimise cleaning, line the pulp container
with a plastic freezer bag to collect the pulp.
Pulp can then be used in other dishes (see page
R12), or as compost for the garden or discarded
(see page 16).

NOTE

Cleaning the motor base
1.

Wipe the motor base with a soft, damp
cloth then dry thoroughly.

2.

Wipe any excess food particles from the
power cord.

Do not use abrasive scouring pads or cleaners
when cleaning the parts or motor base as they
may scratch the surface.

NOTE

Cleaning the fi lter bowl surround, juicer
cover, food pusher, pulp container
1.

Wash all parts in warm soapy water with
a soft cloth. Rinse and dry thoroughly.

The fi lter bowl surround, juicer cover and pulp
container are dishwasher safe (top shelf only).

NOTE

Cleaning the fi lter basket
For consistent juicing results always
ensure that the stainless steel fi lter basket
is thoroughly cleaned using the supplied
cleaning brush.
1.

Soak the stainless steel fi lter basket
in hot soapy water for approximately
10 minutes immediately after juicing
is completed. If pulp is left to dry on
the fi lter it may clog the fi ne pores of
the fi lter mesh thereby lessening the
eff ectiveness of the juicer.

2.

Using the cleaning brush, hold the fi lter
basket under running water and brush
from the inside of the basket to the outer
rim. Avoid touching the small sharp
blades in the centre of the fi lter basket.
After cleaning the fi lter basket, hold it
up towards a light to ensure the fi ne
mesh holes are not blocked. If the holes
are blocked, soak the fi lter basket in hot
water with 10% lemon juice to loosen the
blocked holes. Alternatively, wash the
fi lter basket in the dishwasher.

Advertising