BoonDocker HONDA CRF: 450 - Manual (Page 2)

Revised 2/28/2014 Page 2 of ?
www.boondockers.com………………..... ……….………………....877-522-7805
1. Remove the seat, tank, side panels, sub frame
and air box. Remove air temp sensor from air
box. Install the control box now. 2. Cut fuel line 2” from hose end. Put a clamp on
each cut end and insert brass T fitting on auxil-
iary injector line face towards the back of the
bike. Route under frame.
3. When installing the intercooler the 2” long
piece of silicone tube goes between the throttle
body & intercooler. 3” piece goes between the
turbo & intercooler. 4. Put injector in place with silicone before in-
stalling intercooler and face the plug towards the
throttle body. Install the temp sensor so the plug
is facing upward (as shown).
5. Install exhaust inlet with the clamp placed at
the end of the manifold. Leave clamp loose till
turbo and brackets are tightened in place. 6. Place oil drain line like shown with the brack-
ets shown through the frame. Use chain guard
bolt to fasten the bracket down. Also to the
bracket just under the ECU with a bolt & nut.