BoonDocker HONDA CRF: 450 - Manual (Page 3)

Revised 2/28/2014 Page 3 of ?
www.boondockers.com………………..... ……….………………....877-522-7805
7. On the banjo bolt 2 copper washers on the
inside, 1 on the outside by the bolt head. Route
along right side of Timbersled frame to the
turbo. 8. Route oil feed line along drain line till the
back of the intercooler. Use smaller bolt and
copper washers them tighten down on oil filter
cover.
9. Drill a 3/4” hole on the rear fender for the
feed line to go through. 10. Trim fender like shown to fit around inter-
cooler and exhaust inlet (this is from the front of
the fender view).
11. Trim fender as shown to clear the waste gate
actuator rod. 12. Trim fender to fit around the actuator and
bracket.