BoonDocker HONDA CRF: 450 - Manual (Page 4)

Revised 2/28/2014 Page 4 of ?
www.boondockers.com………………..... ……….………………....877-522-7805
13. Install gasket between flanges, put the bolts
and nuts loosely on. Tighten the silicone clamp
down and the exhaust bolts down after step #15. 14. Run feed line along the left side of inter-
cooler up to the 3/4” hole drilled & zip tie in
place.
15. Place muffler as shown with the Bracket. Put
nuts on the muffler evenly do not tighten yet.
Place a bolt on the exhaust and actuator bracket
to fasten turbo to the frame. Tighten evenly. 16. Place muffler support bracket in place leave
bolts loose until the muffler bracket clamp is
tightened.
17. Place clamp around the muffler and support.
As you tighten down. Keep it aligned and in
place. You may have to lift on the muffler to
align correctly. Tighten all turbo bolts. 18. Route drain line, install line to turbo drain &
zip tie the line to the timber sled frame (as
shown). Tighten hose clamp for drain.