Country Flame LR-01 - Manual (Page 16)

Version 1.0 Page 16
1. Ensure that the Pre-Operation Notes in this manual have been read and understood.
2. Remove hopper lid and fill hopper with pellets. Replace hopper lid.
3. “Prime” the new pellet stove with fuel. Priming fills the auger with pellets. This normally
needs to be done when the stove is new or whenever the stove auger has been run empty. To
prime the stove press the “on/off” button on the control and hold it in for 15 seconds until the
green light by the auger symbol comes on and then release the “on/off” button. The heat level
indicator lights on the control panel will then light from the low to high settings and repeat.
The prime setting will stay on for 5 minutes or until the operator pushes the “on/off” button.
When you see pellets begin to drop in the fire pot you will know that the auger is primed with
fuel. Turn off the “prime” feature by holding in the “on/off” button for 5 seconds. It is then
best to empty the fire pot of pellets if a large quantity of pellets has been allowed to feed into
the firepot and begin the lighting process.
4. Push and hold the “ON/OFF” button on the control board for 5 seconds until the green light
next to the “on/off” button lights up. Release “ON/OFF” button. Your unit is now in the start-
up mode and the red light next to the igniter symbol and the green light next to the auger
symbol will come on.
5. The stove will automatically light and complete the ignition cycle. Adjustment of the air
damper control may be necessary depending on the cleanliness of the stove and present
weather conditions.
6. When the ignition cycle is complete the stove will start up in the # 3 heat setting.
7. Set the control setting at the desired feed rate by pushing the red or blue arrow buttons.
8. The Room Air Blower will activate once the heat sensor warms up. This takes a few minutes.
9. There will be some odor as the paint cures when the stove is new. This is normal
10. You are now ready to enjoy your new Country Flame Pellet stove.
11. In the unlikely event that the ignition system should ever fail, you may use Starting Gel to light
the pellets.
12. Starting Gel or Fluid can be obtained from your Hearth store. DO NOT USE CHARCOAL
LIGHTER!! Place pellets in the firepot by hand. Squirt gel on top of the pellet bed in the
firepot. Immediately light the gel and close the door. Once the pellets are burning, push the
“On/Off” button until the light turns green. Release the “On/Off” button and monitor the stove
start up for a few minutes.
13. Questions or concerns about lighting or other stove operations should be directed to a local
Country Flame dealer.
14. OPTIONAL THERMOSTAT: Contact your Country Flame dealer.