EFCO E-Lite - Manual (Page 19)

EFCO CORPORATION 6/2012 PART NO. YWLS Page 19 of 19
E-Lite Fabrication, Assembly and Installation Instructions
Section XIII: E-Lite Module Alignment Clips Installation
Alignment Clip
Alignment Clip TEK Screws
1.) Attach Alignment Clip.
A.) Locate the alignment clips at the nominal 1/8” module gaps. The clips are designed
to bridge the gap and clear all of the module frame assembly screws.
B.) Attach the clip with the Tek screws supplied. One (1) screw for each of the fixed holes
first and one (1) screw in the approximate center of the adjacent slotted hole into the
next light shelf module. It is expected that some minor alignment / adjustments will be
needed before the clip is firmly seated, and then the screws are tightened.
C.) See SECTION VI for the Face Cap Attachment and SECTION VII for the End Cap Attachment.