EFCO E-Lite - Manual (Page 9)

EFCO CORPORATION 6/2012 PART NO. YWLS Page 9 of 19
E-Lite Fabrication, Assembly and Installation Instructions
Section V: E–Lite “Stick Built” Terminator Channel Attachment
#13E0
1. Fabricate and Install Terminator Channel.
A.) The terminator channel must be cut to length. Locate and drill all strut attachment holes in the channel.
B.) Align the holes in the terminator channel with the races in the end of the strut, and attach with the lead-point
screws. After all screws have been started, go back and tighten all screws firmly.
Terminator Channel
Support Strut
Glazed Wall / Substrate
Support Strut
Terminator Channel
Glazed Wall / Substrate