ETS-Lindgren FP5080 Isotropic Electric Field Probe (Archived) - Manual (Page 11)

Isotropic Electric Field Probe
© ETS-Lindgren, June, 2005
Revision F, Part # 600057 11
2. GETTING STARTED
UNPACKING AND ACCEPTANCE
Step 1. Upon delivery of your order, inspect the shipping
container(s) for evidence of damage. Record any damage on
the delivery receipt before signing. In case of concealed
damage or loss, retain the packing materials for inspection by
the carrier.
Step 2. Remove the probe from its shipping containers. Save
the boxes and any protective packing materials for future use.
Step 3. Check all materials against the packing list to verify that
the equipment received matches what was ordered. If you find
any discrepancies, note them and call ETS-Lindgren Customer
Service for further instructions.
Be sure that you are satisfied with the contents of your order and
the condition of your equipment before installing the probe.
PROBE
A switch, two fiber optic connectors and a battery charger
connector are mounted on the HI-4450/FP2080/FP4080/FP5080
electronics housing (Figure 2).
Archived 4/02/10