ETS-Lindgren HI-4455 Isotropic Field Probe (Archived) - Manual (Page 39)

HI-4455 Isotropic Electric Field Probe
© ETS-LINDGREN L.P. – August 2005
Revision D- Part No. H-600076 39
General Safety Considerations
This symbol alerts the user that important literature
concerning the operation and maintenance of this
unit has been included. Therefore, it should be read
carefully in order to avoid any problems.
Warning
This is a Safety Class I product (provided with a
protective earthing ground incorporated in the power
cord). The mains plug shall only be inserted in a
socket outlet provided with a protective earth contact.
Any interruption of the protective conductor, inside or
outside the instrument, is likely to make the
instrument dangerous. Intentional interruption is
prohibited. DO NOT defeat the earth-grounding
protection by using an extension cable, power cable,
or autotransformer without a protective ground
conductor
This instrument is to be used with a three-wire power
cord set which meets or exceeds the requirements of
EN60799. The power cord set used must be rated
for a minimum of 250V/10A. When connected to an
appropriate power line outlet, this cable grounds the
instrument cabinet
Warning
No operator serviceable parts exist inside the device.
Refer servicing to qualified personnel. To prevent
electrical shock, do not remove cover.
Warning
If this instrument is used in a manner not specified by
ETS-Lindgren, the protection provided by the
instrument may be impaired.
Warning
This battery charger incorporates parts, such as a
switch and relay that potentially could produce sparks
or arcs.
Warning
For indoor use only, do not expose to rain.
This page intentionally left blank.
Archived 4/2/10