ETS-Lindgren HI-4455 Isotropic Field Probe (Archived) - Manual (Page 45)

HI-4455 Isotropic Electric Field Probe
© ETS-LINDGREN L.P. – August 2005
Revision D- Part No. H-600076 45
3.0 Specifications
POWER
Main: IEC filtered AC power input module
110 - 240 Vac, 500 mA MAX., 50 - 100 Hz
Alternate: Automobile cigarette lighter to 2mm power plug adapter
cord., 12.5 Vdc, 100 mA
Fuses: 250 Volt, 1.0 Amp, Type T (5 mm x 20 mm)
OUTPUT
Open Circuit Voltage: 15 Vdc
Fast Charge Pending Current: 60 mA
Fast Charge Current: 1400 mA
Pulsed Trickle Charge Current: 50 mA
Output Voltage (During Fast Charge): 3 - 6 Vdc
NICD BATTERY:
3.6 Volt 3 Cell NiCd Battery, 1400 mAH (Rapid charge cells, 1.2
volts/cell); ETS-Lindgren Part #491038
ENVIRONMENTAL
Operating temperature 10 to 40 { C
Humidity: 5% to 95% relative humidity, non-
condensing
POWER CABLE
This charger is shipped with a three-wire power cable. When this cable
is connected to an appropriate AC power source, it connects the chassis
to earth ground. The type of power cable shipped with each battery
charger depends on the country of destination.
Archived 4/2/10