Hybrid Racing HR K-Series Fuel Rail - Manual (Page 3)

3
Install Guide
STEP 1:
Using a 10mm socket, remove
the (2) caps nuts holding the cov-
er in place (FIG 1). Once these
are removed, pull the cover off.
This will take some force, the
cover is held on with rubber
grommets.
STEP 2A:
Unplug all (4) injector wires from
the injectors and using your
10mm socket again, remove the
ground connection from the in-
take manifold as illustrated in FIG
2A.
STEP 2B:
Using a flat head screwdriver, un-
clip the injector harness from the
fuel rail as illustrated in FIG 2B.
Once both clips are undone, slide
the harness off and set it to the
side.