Hybrid Racing HR K-Series Fuel Rail - Manual (Page 7)

7
Install Guide
STEP 13:
Plug all (4) injectors back in.
Then, using a 10mm socket re-
move the cap nut on the valve
cover, relocate the injector
ground wire to that stud, and
tighten the cap nut back on top
as shown in FIG 13. Note: if the
correct wire is not on the corre-
sponding injector the car will not
run correctly.
STEP 12:
Using a 10mm socket, remove the metal plate the MAP sensor wire is clipped to.
Then with some pliers, squeeze the clip and pull the wire off of the metal plate. (FIG
12A and FIG 12B)
STEP 14 (optional) :
Reinstall the injector cover that
was removed in step 1, or you
can leave it off and show off your
new Hybrid Racing fuel rail!