Kendon Dual Ride-Up SRL Stand-Up User Manual

Page 11

Advertising
background image

714-630-7144

www.KendonUSA.com

- 9 -

Installation, Use and Storage of Dual Ride-Up Foot Extension

There is only one (1) Ride-Up Foot Extension. It is used for both the left and
right side for loading and unloading. This foot extension is designed only for a
place to put your foot and to support the rider for balance only.

THE FOOT EXTENSION IS NOT INTENDED TO SUPPORT THE WEIGHT
OF A MOTORCYCLE OR THE PULLING WEIGHT OF A TIE DOWN. DO
NOT USE AS A TIE DOWN POINT. DAMAGE OR INJURY COULD OCCUR
IF IMPROPERLY USED.



Loading and Unloading:

Select the side you are going to load your motorcycle. Insert the small end tubes
of the foot extension into the large open tube section of the rear trailer frame.
Align the hinge tabs on the foot extension and the rear frame and insert detent
pins (refer to illustration below).



Foot Extension Storage for Towing:

Rear section foot extension must be removed and stored in tow vehicle when
towing. DO NOT leave foot extension on trailer while towing. Place extension in

Advertising