Kendon Dual Ride-Up SRL Stand-Up - Manual (Page 9)

714-630-7144 www.KendonUSA.com
- 7 -
Usage Instructions for Kendon Ride-Up Single SRL Trailer
Thoroughly read and understand these instructions and the attached Owner’s
Manual for Kendon Stand-Up™ Trailers.
Attach the Trailer to Tow Vehicle making sure the coupler completely engages
the ball and that the coupler latch is locked down. Refer to the diagram below
for an illustration of the coupler latch in the closed position.
Coupler Latch in Properly Closed Position
Proper Ramp Attachment for Loading & Unloading
Only the center of the ramp is to be used to support the weight of the
motorcycle while loading and unloading. The fold-out side wings, or side
steps, are for foot support only.
Attach ramp to rear of trailer. The ramp installs in either of two positions; left or
right.
Look directly at the new rear section of your new DRU (Dual Ride-Up), you will
see open slots that line up with the ramp hooks. These slots are also marked
with red “Insert Ramp Here” stickers. The ramp hooks must go into these slots
only.
• Begin with ramp in closed position (side foot boards closed)
• Hold ramp at approximately 45 degree angle (ramp hooks are down, rear
of ramp is up at approximately 45 degrees)
• Line up ramp hooks with slots on the rear section of the trailer
• Insert ramp hooks into slots (hooks should look like a spoon facing up)