Kontron CP346 - Manual (Page 62)

Rear I/O Modules CP346
Page 5 - 8 © 2005 Kontron Modular Computers GmbH ID 27253, Rev. 03
P R E L I M I N A R Y
5.1.3 Single-Channel Front Panel Adapter
In order to comply with standard PC interface technology, a single-channel RJ45-to-D-Sub
front panel adapter (CP-ADAP-RJ45-DSUB9-PC) can be connected to the RJ45 frontend con-
nector of each channel of the non-optoisolated rear I/O module (CP-RIO3-46). This adapter
terminates on the user side with a 9-pin, male, D-Sub connector which includes the signals of
the relating channel. The shielded adapter cable has a length of approximately 15 cm.
Figure 5-5: Four-Channel Front Panel Adapter
Warning!
Where signals are not indicated in the table below, do not connect
external wiring to the connector pins. Failure to comply may result in
damage to the RIO module.
Table 5-2: Pinouts of RJ45-to-D-Sub Frontpanel Adapter Connectors
RJ45
CONNECTOR
RS232
9-PIN ROW
CONNECTOR
CHANNEL
1 DSR 6
n with
n = 0..3
2 RTS 7
3 GND 5
4 TxD 3
5 RxD 2
6 DCD 1
7 CTS 8
8 DTR 4
— — 9
Channel 0..3
9-pin D-Sub RJ45
Connector Connector