3 four-channel frontpanel adapter, Four-channel frontpanel adapter - 14, 10 four-channel front panel adapter - 14 – Kontron CP346 User Manual
Page 68: Rear i/o modules cp346
Rear I/O Modules
CP346
Page 5 - 14
© 2005 Kontron Modular Computers GmbH
ID 27253, Rev. 03
P R E L I M I N A R Y
5.2.3
Four-Channel Frontpanel Adapter
In order to provide separate serial I/O channelling, a four-channel front panel adapter (CP-
ADAP-CP345-DSUB50) can be connected to the 50-pin frontend connector of this optoisolated
rear I/O module. This adapter terminates on the user side with four, male, 9-pin, D-Sub
connectors which include the signals of channels 0 to 3. The adapter cables have a length of
approximately 15 cm.
Note...
The port labelling on the 9-pin D-sub connectors is different to the channel
numbering on the CP346.
Channel 0 corresponds to Port 1
Channel 1 corresponds to Port 2
Channel 2 corresponds to Port 3
Channel 3 corresponds to Port 4
Warning!
Where signals are not indicated in the table below, please do not con-
nect external wiring to the connector pins. Failure to comply may result
in damage to your board.
Channel 0
Channel 1
Channel 2
Channel 3
9-pin D-Sub
50-pin D-Sub
Connectors
Connector
Port 1
Port 4
Port 3
Port 2
Figure 5-10: Four-Channel Front
Panel Adapter