Kontron CP-RIO3-04S - Manual (Page 36)

Installation CP-RIO3-04S
Page 3 - 4 ID 1036-1669, Rev. 1.0
3.2 Initial Installation Procedures
The following procedures are applicable only for the initial installation of the CP-RIO3-04S in a
system.
To perform an initial installation of both the CP-RIO3-04S in a system, proceed as follows:
1. Ensure that the safety requirements indicated in Chapter 3.1 are observed.
2. Ensure that the CP-RIO3-04S is compatible with the CPU board and the backplane prior
to installation.
3. If appropriate, ensure that the onboard peripheral devices are properly installed prior to
installation of the CP-RIO3-04S.
4. Ensure that no power is applied to the system before proceeding.
5. Carefully insert the CP-RIO3-04S into the slot designated by the application require-
ments for the CP-RIO3-04S until it makes contact with the backplane connector.
6. Using the ejector handle, engage the CP-RIO3-04S with the backplane. When the ejector
handle is locked, the CP-RIO3-04S is engaged.
7. Fasten the front panel retaining screws.
8. Connect all external interfacing cables to the CP-RIO3-04S as required.
9. Ensure that the CP-RIO3-04S and all required interfacing cables are properly secured.
The CP-RIO3-04S is now ready for initial operation.
Warning!
Failure to comply with the instruction below may cause damage to the
CP-RIO3-04S or result in improper system operation.
Warning!
Even though power may be removed from the system, the CP-RIO3-04S
front panel cables may have power applied which comes from an external
source.
In addition, these cables may be connected to devices that can be dam-
aged by electrostatic discharging or short-circuiting of pins.
It is the responsibility of the system designer or integrator to ensure that
appropriate measures are taken to preclude damage to the system or inju-
ry to personnel which may arise from the handling of these cables (con-
necting or disconnecting).
Kontron disclaims all liability for damages or injuries resulting from failure
to comply with the above.
Warning!
When performing the next step, DO NOT push the CP-RIO3-04S into the
backplane connector. Use the ejector handle to seat the CP-RIO3-04S into
the backplane connector.