Kontron CP-RIO3-04S - Manual (Page 37)

CP-RIO3-04S Installation
ID 1036-1669, Rev. 1.0 Page 3 - 5
3.3 Standard Removal Procedures
To remove the CP-RIO3-04S proceed as follows:
1. Ensure that the safety requirements indicated in Chapter 3.1 are observed.
2. Ensure that no power is applied to the system before proceeding.
3. Disconnect any interfacing cables that may be connected to the CP-RIO3-04S.
4. Unscrew the front panel retaining screws.
5. Disengage the CP-RIO3-04S from the backplane by first unlocking the ejection handle
and then by pressing the handle as required until the CP-RIO3-04S is disengaged.
6. After disengaging the CP-RIO3-04S from the backplane, pull it out of the slot.
7. Dispose of the CP-RIO3-04S as required.
Warning!
Care must be taken when applying the procedures below to ensure that
neither the CP-RIO3-04S nor system boards are physically damaged by
the application of these procedures.
Warning!
Even though power may be removed from the system, the CP-RIO3-04S
front panel cables may have power applied which comes from an external
source.
In addition, these cables may be connected to devices that can be dam-
aged by electrostatic discharging or short-circuiting of pins.
It is the responsibility of the system designer or integrator to ensure that
appropriate measures are taken to preclude damage to the system or inju-
ry to personnel which may arise from the handling of these cables (con-
necting or disconnecting).
Kontron disclaims all liability for damages or injuries resulting from failure
to comply with the above.