Kontron CP6003-RC IPMI - Manual (Page 17)

CP6003-SA/RA/RC IPMI Firmware
ID 1045-5656, Rev. 2.0 Page 17
P R E L I M I N A R Y
Get Chassis Status 28.2 Chassis 01h O / Yes
Chassis Control 28.3 Chassis 02h O / Yes
Chassis Reset 28.4 Chassis 03h O / No
Chassis Identify 28.5 Chassis 04h O / No
Set Chassis Capabilities 28.7 Chassis 05h O / No
Set Power Restore Policy 28.8 Chassis 06h O / No
Get System Restart Cause 28.11 Chassis 07h O / No
Set System Boot Options 28.12 Chassis 08h O / No
Get System Boot Options 28.13 Chassis 09h O / No
Get POH Counter 28.14 Chassis 0Fh O / Yes
EVENT COMMANDS M
Set Event Receiver 29.1 S/E 00h M / Yes
Get Event Receiver 29.2 S/E 01h M / Yes
Platform Event (a.k.a. “Event Message”) 29.3 S/E 02h M / Yes
PEF AND ALERTING COMMANDS O
Get PEF Capabilities 30.1 S/E 10h O / No
Arm PEF Postpone Timer 30.2 S/E 11h O / No
Set PEF Configuration Parameters 30.3 S/E 12h O / No
Get PEF Configuration Parameters 30.4 S/E 13h O / No
Set Last Processed Event ID 30.5 S/E 14h O / No
Get Last Processed Event ID 30.6 S/E 15h O / No
Alert Immediate 30.7 S/E 16h O / No
PET Acknowledge 30.8 S/E 17h O / No
SENSOR DEVICE COMMANDS M
Get Device SDR Info 35.2 S/E 20h M / Yes
Get Device SDR 35.3 S/E 21h M / Yes
Reserve Device SDR Repository 35.4 S/E 22h M / Yes
Get Sensor Reading Factors 35.5 S/E 23h O / No
Set Sensor Hysteresis 35.6 S/E 24h O / Yes
Get Sensor Hysteresis 35.7 S/E 25h O / Yes
Set Sensor Threshold 35.8 S/E 26h O / Yes
Get Sensor Threshold 35.9 S/E 27h O / Yes
Table 3: Standard IPMI Commands (Continued)
COMMAND
IPMI 2.0
SPEC.
SECTION
NETFN CMD
KONTRON
SUPPORT
ON IPMI
CONTROLLER