Kontron CP6003-RC IPMI - Manual (Page 33)

CP6003-SA/RA/RC IPMI Firmware
ID 1045-5656, Rev. 2.0 Page 33
P R E L I M I N A R Y
8.5.2 Firmware Upgrade - “ipmitool hpm”
Firmware upgrade using a HPM.1 file requires at least “ipmitool” version 1.8.10.
The firmware upgrade procedure starts with downloading the HPM.1 file using, for example,
the following command:
The next step is the activation of the newly downloaded IPMI firmware. This is done using:
Detailed information about the currently active firmware versions or the redundant copies can
be obtained using the commands mentioned below.
To obtain detailed version information of the active IPMI firmware, use the following command:
To obtain the version of the rollback copy (only valid if a newly downloaded firmware is already
activated), use the following command:
To obtain the version of the newly downloaded IPMI firmware (only valid after download and
before activation), use the following command:
To obtain detailed information about the IPMI HPM.1 upgrade capabilities, use the following
command:
ipmitool hpm upgrade <HPM.1_FWFile>.hpm all
ipmitool hpm activate
ipmitool hpm compprop 1 1
ipmitool hpm compprop 1 3
ipmitool hpm compprop 1 4
ipmitool hpm targetcap