Kontron KTHM76-mITX - Manual (Page 127)

KTQM77 – KTHM76 Users Guide
KTD-N0850-F Page 127
Table continued:
Function Selection Description
Max TOLUD
Dynamic
1 GB
1.25 GB
1.5 GB
1.75 GB
2 GB
2.25 GB
2.5 GB
2.75 GB
3 GB
3.25 GB
Maximum Value of TOLUD.
Dynamic assignment would adjust TOLUD
automatically based on largest MMIO length of
installed graphic controller.
NMode Support
Auto
1N Mode
2N Mode Nmode Support Option
Memory Scrambler
Enabled
Disabled
Enable or disable memory scrambler.
MRC Fast Boot
Enabled
Disabled
Enable or disable MRC Fast Boot
Force Cold Reset
Enabled
Disabled
Force cold reset or choose MRC cold reset
mode, when cold boot is required during MRC
execution. Note: If ME 5.0MB is present, Force
cold reset is required!
DIMM Exit Mode
Auto
Slow Exit
Fast Exit
DIMM Exit Mode control.
Power Down Mode
No Power Down
APD
PPD
APD-PPD
Power Down Mode control.
Scrambler Seed
Generation Off
Enabled
Disabled
Control Memory Scrambler Seed Generation.
Enable – do not generate scrambler seed.
Disable – Generate scrambler seed always.
Memory Remap
Enabled
Disabled
Enable or disable Memory Remap above 4G.
Memory Alias Check
Enabled
Disabled
Enable or disable Memory Alias Check.
Channel A DIMM Control
Enable Both DIMMS
Disable DIMM0
Disable DIMM1
Disable Both DIMMS
Enable or disable dims on channel A.
Channel B DIMM Control
Enable Both DIMMS
Disable DIMM0
Disable DIMM1
Disable Both DIMMS
Enable or disable dims on channel B.
BIOS - Chipset