Channel Vision 6128 - Manual (Page 25)

24
Detection Block Setup: Press MENU button to enable or disable a single
cell configuration setting Use up and down keys to move around or to end
the setting mode. Press MENU button for 3 seconds to leave the setting
page.
Keyboard Operation: Use the joystick to move the direction up, down, left or
right and to move the cursor. Press ? IRIS OPEN? button to enable or disable a
single cell configuration setting and press ? IRIS CLOSE? button to leave the
Motion Mask Setting page.
3. SENSITIVITY: Detection sensitivity can be set to the range of 0 ~ 63 (Default
Setup: 10).
4. DURATION: Alarm dura tion that arises after the motion alarm can be set to 5S
/ 10S / 15S / 20S / 30S / 1M / 2M / 3M / 4M / 5M (Default Setup: 5S). When an
alarm has been triggered, a symbols "M" appears on the lower-left corner of the
screen, and sends out a high Level 5V sound from the rear panel. When the
alarm ends, the symbol "M" disappears, and sends out a Low Level sound from
the rear panel.
5. DEFAULT: Return to default setup.
6. RETURN: Return to previous status.
8.3.9 COMMUNICATION Setup:
COMMUNICATION
CAMERA ID
PROTOCOL
SPEED
PARITY
RETURN
1
AUTO
9600
NONE
猀 琀
Please refer to ? 6. INSTALLATION? for more information on Communication.