La-Z-Boy Platinum Luxury-Lift Power Recliner - Manual (Page 4)

F IGURE 2
F IGURE 3
Tie Securing Hand Wand, Power Cord
and Power Transformer
F IGURE 1
Massage & Heat
Connectors –
Red & Green
Locking Lever
F IGURE 6 F IGURE 5
Body Bracket
Back Bracket
Platinum Luxury-Lift ® Assembly Instructions Platinum Luxury-Lift ® Assembly Instructions
1. Choose a location for the lift chair that is close to an electrical outlet.
2. Starting with the unit removed from the carton and the back laying off to the side, carefully cut the
cable tie holding the hand wand, power cord and power transformer box to the chair (F IGURE 1). Set
the power cord and box aside. Remove the packing material from the hand wand, unwind the cord
and lay the hand wand on the seat.
3. The power supply connector is tucked behind the upholstered tailgate (F
IGURE 2). Carefully remove
the power supply connector from the tailgate.
4. Lay the back across the chair arms with the back cushion facing the seat and turn the outside
back cover over, toward the front of the chair.
• Turn the locking levers, located on the brackets attached to the back (one on each side), to a
90 degree angle (F IGURE 3).
• Note the location of the fastening tape sewn to the cover (F IGURE 2). Do not attach the
fastening tape at this time.
5. Identify and make the electrical connections between the back and the body (F
IGURE 2 and
F IGURE 4). The hand wand connection is the only connection to be made on chairs without
massage and heat. Chairs with massage and heat require two additional connections, the
massage and the heat.
• Connect the hand wand. Locate the two black round connectors. Align the arrows on the
connectors, push the connectors together and close the locking cover to secure the
connection (F
IGURE 4).
• For chairs with massage and heat features:
- Connect the heat. Locate the 2-pin red (from the back) and black (from the body)
connectors. Align the connectors and push together until locked.
- Connect the massage. Locate the 6-pin green (from the back) and green (from the base)
connectors. Align the connectors and push together until locked.
– To reduce the risk of injury:
• Do not operate the unit until the back is installed and locked.
WARNING
6. Install the back.
• With the back across the chair arms, lift the back at a slight angle and align the brackets on
the back with the brackets on the body (F IGURE 5).
• Lower the back onto the body, making sure the back and body brackets are completely engaged.
- To make sure the back is properly installed with both sets of back and body brackets engaged,
stand behind the chair and twist the back from side to side. If one or both sides move out of
position the brackets are not engaged (F
IGURE 6). Remove the back and repeat the steps above.
- If you are unable to install the back properly, contact your La-Z-Boy ® dealer for assistance.
• Lock the brackets by using hand pressure or a screwdriver to push down the locking levers
(F
IGURE 7 on page 9).
(Assembly Instructions Continued)
7 6
– To reduce the risk of product damage:
• Do not plug the transformer in until instructed.
NOTICE
Power Supply
Connector Tucked
Behind Tailgate
Hand Wand
Connector –
Black Round
Fastening
Tape
F IGURE 4
Green and Green
(6
-pin) Connectors
Red and Black
(2
-pin) Connectors
Hand Wand
Connectors with
Locking Cover
Back Bracket
Images feature the Platinum lift chair with massage and heat features.
Back and body brackets on this side are not
engaged. Remove the back and reinstall.