La-Z-Boy Platinum Luxury-Lift Power Recliner - Manual (Page 5)

F IGURE 9
Fastening Tape on the Body
F IGURE 7
120 Volt Power
Cord Connection
Platinum Luxury-Lift ® Assembly Instructions Platinum Luxury-Lift ® Assembly Instructions
9 8
7. Attach outside back cover. The back upholstery cover attaches to the body using fastening tape.
Pull the outside back upholstery cover down tight, and firmly press the fastening tape on the outside
back cover to the fastening tape on the lower sides of the rear body and to the backside of the body
rear rail (F
IGURE 8).
8. Make the power transformer connections.
• Remove power transformer from box and unwind cord.
• Align the power transformer connector to the power supply connector from behind the chair
and push the connectors together until they lock (F
IGURE 9).
• Connect the 120 volt power cord to the power transformer. Align the 120 volt power cord connector
to the power transformer and push together until fully seated (F IGURE 9). Do not plug in until
instructed in the Operating Instructions.
9. Proceed to the Battery Backup Assembly Instructions.
10. To remove the back, unplug the 120 volt power cord from the electrical outlet and disconnect the power
transformer connector from the power supply connector. Reverse the Assembly Instructions steps.
Important: For chairs with massage and heat features, there are electrical connections between the
back and the body. Take care not to damage the wires or connections when lifting the back from the
body and rotating it onto the arms of the chair. Never stretch or strain wires or connections.
Outside Back Upholstery
Fastening Tape
Note: Fastening tape located on bottom
side of the body rear rail is not visible.
Power Transformer/
Power Supply
Connection
Back
Bracket
Locking
Lever
Locked
Position
F IGURE 8