Mercedes-Benz SLS-Class 2015 COMAND Manual - Manual (Page 185)

Operation
You can use voice control at any time to:
R save a name
R select a name
R delete a name
R list the address book
R delete the address book
R open the address book
R open an entry from the address book
R list the phone book
R list the destination memory
X To open the address book: Press
the ? button on the multifunction
steering wheel.
X
Give the “Address book” command.
X Press the ? button.
X
Give one of the address book commands
explained below.
Commands
“Address Book”
X
To open the address book: Say the
command “Address book”.
“Help Address Book”
X Using the “Help address book” command,
you can have all the essential commands
for the address book read out.
“Save Name”
Use the “Save name” command to save a
phone number with a voice name for a
specific speaker. Use this command for a
name which is complicated or which is
pronounced differently as it is spelled, for
example, because it is a foreign name. When
you have given the command “Save Name”,
voice control prompts you to enter a phone
number.
The digits 0 to 9 and the word “Plus” are
permitted.
“Plus” replaces the international dialing code,
e.g. “00”.
Say the phone number in the form of a
continuous string of digits or as blocks of
digits, e.g. three to five digits.
Voice control repeats the digits it recognizes
after each block of digits (with a pause of
about half a second between each block of
digits) and waits for you to continue speaking.
When you have given the command “Okay”,
voice control prompts you two or three times
to say the name. When repeating the name,
make sure that you pronounce it in exactly
the same way as you did the first time.
Otherwise, the name cannot be saved and
voice control aborts the saving procedure.
Example of dialog:
s Save name
t Please say the number
s Zero one three zero
t Zero one three zero
s Five zero zero five
t Five zero zero five
s Okay
t Please say the name.
s Smith
t Please repeat the name.
s Smith
t Would you like to save the number in
a category?
s No
t Name and number saved
“Dial Name”
You can use the “Dial name” command to
place a call by selecting a name from your
address book. You can choose either a voice
name or say a name entry.
Only say the surname if only the surname is
entered in the address book.
Address Book
183
Voice
Control
Z