Mercedes-Benz SLS-Class 2015 COMAND Manual - Manual (Page 78)

3 Information on crosshairs position
4 Set map scale
i The display 3 depends on the settings
selected in “Text information On Map”
(
Y
page 62). It may display the current road
if corresponding data is available in the
digital map. Or it displays the geo-
coordinates position of the crosshairs if
Geo-coordinates display is activated.
Moving the Map and Selecting a
Destination
X To move the map: Slide q m r, o m p or
w m x.
X To set the map scale: Rotate y m z.
Rotating clockwise makes the map smaller,
rotating counterclockwise enlarges it.
X
To select a destination: Press n once or
repeatedly until the Enter Destination
menu is displayed or, if COMAND cannot
define a destination unambiguously, a list
of possible destinations.
X To select a destination: Rotate y m z or
slide q m r.
X Press n.
If the destination is within the digital map,
COMAND tries to find the destination on
the map.
If the destination can be found, the Enter
Destination menu is displayed with the
address of the destination. Otherwise you
will see the entry Destination From
Map .
X To start route calculation: Select Start .
Entering Stopover Destination
i When route guidance is activate, you can
enter a stopover destination. Stopover
destinations may be predefined
destinations in the following categories
suggested by COMAND for you to select:
R ATM/Cash Machine
R Hospital
R Gas Station
R Parking Lot
R Restaurant
However, you can also enter destinations
other than those that have been
predefined. Select the menu item Other for
this purpose.
You can influence the route guidance to the
main destination in a specific way using the
stopover function. Once the stopover
destination has been reached, COMAND
automatically continues the route guidance
to the main destination.
Entering Predefined Destinations
X If necessary switch to navigation mode and
display menu system (
Y
page 57).
X Select Destination £ Stopover .
No Stopover Destination available yet
X
Select a category.
A Stopover Destination exists
X Select Change Stopover to change.
X Select a category.
X Select another stopover destination.
COMAND first searches for destinations
along the route within the selected category.
COMAND then searches for destinations in
the vicinity of the vehicle's location.
76
Destination Input
Na
vigation