Smartkey positions, Driving and parking, Driving – Mercedes-Benz C-Class 2011 Owners Manual User Manual

Page 133

Advertising
background image

G

Warning

On slippery road surfaces, never downshift in
order to obtain braking action. This could
result in drive wheel slip and reduced vehicle
control. Your vehicle's ABS will not prevent
this type of loss of control.

G

Warning

Manual transmission: Wait until the vehicle is
stationary before removing the SmartKey
from the starter switch. The vehicle cannot be
steered when the SmartKey is removed from
the starter switch.

G

Warning

It is dangerous to shift the automatic
transmission out of parking position

P or

neutral position

N if the engine speed is

higher than idle speed. If your foot is not firmly
on the brake pedal, the vehicle could
accelerate quickly forward or in reverse. You
could lose control of the vehicle and hit
someone or something. Only shift into gear
when the engine is idling normally and when
your right foot is firmly on the brake pedal.

!

Warm up the engine quickly. Do not use

the engine's full performance until it has
reached operating temperature.
Only shift the automatic transmission to
the desired drive position when the vehicle
is stationary.
Where possible, avoid spinning the drive
wheels when pulling away on slippery
roads. You could otherwise damage the
drive train.

!

AMG vehicles: at low engine oil

temperatures (below 68 ‡ (+20 †), the
maximum engine speed is restricted in
order to protect the engine. To protect the
engine and maintain smooth engine
operation, avoid driving at full throttle when
the engine is cold.

SmartKey positions

SmartKey

g

To remove the SmartKey
Vehicles with automatic transmission:
shift the transmission to position

P.

1

Power supply for some consumers, such
as the windshield wipers

2

Ignition (power supply for all consumers)
and drive position

3

To start the engine

Once the ignition is switched on, all the
indicator lamps in the instrument cluster light
up. The indicator lamps of the low-beam
headlamps, high-beam headlamps, turn
signal lamps or front fog lamps only light up
if the low-beam headlamps, high-beam
headlamps, turn signal lamps or front fog
lamps are switched on. If an indicator lamp
does not light up when the ignition is switched
on, check it and replace it if necessary. If an
indicator lamp does not go out after starting
the engine or lights up while the vehicle is in
motion, see (

Y

page 203).

If the SmartKey is in position

0 in the ignition

lock for an extended period of time, it can no
longer be turned in the ignition lock. The
steering is then locked. To unlock, remove the
SmartKey and reinsert it in the ignition lock.
The steering is locked when you remove the
SmartKey from the ignition lock.

X

Remove the SmartKey when the engine is
switched off.
The battery may otherwise discharge.

Driving

131

Driving and parking

BA 204 USA, CA Edition A 2011; 1; 5, en-US
hereepe

Version: 3.0.3.6

2010-05-20T09:17:30+02:00 - Seite 131

Z

Advertising
This manual is related to the following products: