Towing the vehicle with the rear axle raised, Towing vehicles with both axles on the ground, Breakdown assistance – Mercedes-Benz C-Class 2011 Owners Manual User Manual

Page 267: Towing and tow-starting

Advertising
background image

X

Press the mark on cover : inwards, in the
direction of the arrow.

X

Take cover : off the opening.

X

Screw in and tighten the towing eye
clockwise to the stop.

Removing the towing eye

X

Unscrew and remove the towing eye.

X

Attach cover : to the bumper and press
until it engages.

X

Place the towing eye in the vehicle tool kit.

Towing the vehicle with the rear axle

raised

Only possible for vehicles without

4MATIC.
When having your vehicle towed with the rear
axle raised, observe the important safety
notes (

Y

page 264).

!

The ignition must be switched off if you

are towing the vehicle with the rear axle
raised. Intervention by ESP

®

could

otherwise damage the brake system.

X

Switch on the hazard warning flashers
(

Y

page 109).

X

Turn the SmartKey to position

0 in the

ignition lock and remove the SmartKey.

X

When leaving the vehicle, take the
SmartKey or the KEYLESS-GO key with you.

Towing vehicles with both axles on

the ground

When having your vehicle towed, observe the
important safety notes (

Y

page 264).

G

Warning

With the engine not running, there is no power
assistance for the brake and steering
systems. In this case, it is important to keep
in mind that a considerably higher degree of
effort is necessary to brake and steer the
vehicle. Adapt your driving accordingly.

X

Turn the SmartKey to position

2 in the

ignition lock.

X

When the vehicle is stationary, depress the
brake pedal and hold it down.

X

Vehicles with manual transmission:

depress the clutch pedal.

X

Shift to neutral.

or

X

Vehicles with automatic transmission:

shift the automatic transmission to
position

N.

X

Release the brake pedal.

X

Release the parking brake.

X

Switch on the hazard warning flashers
(

Y

page 109).

i

When towing with the hazard warning

flashers switched on, use the combination
switch as usual to signal in which direction
you are changing. In this case, only the
indicator lamps for the direction of travel
flash. When you reset the combination
switch, the hazard warning flashers start
flashing again.

Towing and tow-starting

265

Breakdown assistance

BA 204 USA, CA Edition A 2011; 1; 5, en-US
hereepe

Version: 3.0.3.6

2010-05-20T09:17:30+02:00 - Seite 265

Z

Advertising
This manual is related to the following products: