Mercedes-Benz C-Class 2009 COMAND Manual - Manual (Page 100)

Activating the Mobile Phone
98
i On certain mobile phones, not only do you
have to activate the Bluetooth function but
the device must also be made “visible” for
other devices.
Each Bluetooth device has a Bluetooth
device name. It is recommended to give the
device a personal name, by which you can
clearly recognize your mobile phone.
i If the Bluetooth function on the COMAND
is switched off, the message Bluetooth
not activated in system settings.
appears.
X Activate Bluetooth connection on
COMAND (
Y page 43).
Registering a Mobile Phone
(Authorizing)
When you use your mobile phone in
conjunction with COMAND for the first time,
you must register (authorize) it.
It is possible to register several mobile
phones. The connection is always established
to the mobile phone that was activated last.
When you authorize a new mobile phone, it is
activated automatically. You can switch
between the authorized mobile phones
(
Y page 100).
Searching for a Mobile Phone
X In the phone submenu select Phone
£ Phone List £ Update.
COMAND searches for suitable Bluetooth
phones within range and enters them in the
phone list.
i The duration of the search procedure
depends on the number and type of
Bluetooth phones. The search may take a
few minutes.
When first entering the device list and before
running an update, the black dot
R indicates
the active phone (found and authorized).
After running an update:
1 The check marks Ò indicate if a phone
has been authorized (black) or not (grey)
2 Device not within range but previously
authorized (
¿ appears in grey)
3 Phone icons indicate if a phone is found
(black) or not (grey)
i If the device list already contains ten
authorized devices, you must de-authorize
one of the authorized devices
(
Y page 100). You will then have to switch
this device off and start the search again.
Otherwise the new device you are looking
for will not appear in the list.
X To start search again: Select Update
Telephone