Navigation – Mercedes-Benz C-Class 2009 COMAND Manual User Manual
Page 60
Introduction
58
Setting Route Options
X
To set: Display menu system is applicable
X
Select Navi
£
Mode.
X
To switch option on/off: Select required
option.
Depending on the previous status, the
option will be switched on
Ç
or off
c
.
You may activate several options.
i
The calculated route may include ferry
connections, for example, even if the
operation Avoid Ferries has been
activated.
i
If you change the route type setting when
route guidance is active, COMAND
calculates a new route.
Block Area
You can define an area within the map display
that is not to be used by the system in
calculating a route, if possible.
i
The calculated route may include a
blocked area if the destination is within a
blocked area or if the destination can only
be reached using roads that lead through a
blocked area. Highways cannot be blocked.
X
To set, change or delete: Display mennu
X
Select Navi
£
Block Area.
If no areas were previously set, the map
display appears ready to select an area.
X
Slide
q
m
r
,
o
m
p
or
w
m
x
to select an area.
X
Press
n
.
The blocked area appears in red.
X
Rotate
y
m
z
to change the size of the
blocked area.
X
Press
n
.
The area is added to the blocked area list.
A checked entry indicates an active blocked
area.
i
You can block several areas for the route
calculation and activate or de-activate
them by setting or removing the check
mark.
Displaying and Changing an Existing
Block Area
X
To select the area you want to display
or change: Slide
q
m
r
.
X
Select Display/Change.
The map display appears with the block
area marked red.
X
Rotate
y
m
z
until the desired size of the
block area is set.
Navigation