Mercedes-Benz SL-Class 2009 Owners Manual - Manual (Page 137)

Control system
135
X Press button è or ÿ repeatedly until
the Vehicle status message memory
menu appears in the multifunction display.
If conditions have occurred causing status
messages to be recorded, the number of
messages appears in the right multifunc-
tion display:
1 Number of recorded status messages
X Press button j or k .
The stored messages will now be displayed
in the order in which they have occurred.
For malfunction and warning messages,
see “Vehicle status messages in the multi-
function display” (
Y page 255).
i After you have scrolled through all
recorded status messages, the first
recorded message appears again.
Should the vehicle’s system record any con-
ditions while driving, the number of messages
will reappear in the multifunction display
when the SmartKey in the starter switch is
turned to position
0 or removed from the
starter switch. With KEYLESS-GO the number
of messages will reappear when you turn off
the engine by pressing the KEYLESS-GO
start/stop button and open the driver’s door.
Except for high-priority messages, the vehicle
status message memory will be cleared when
you turn off the ignition.
Settings menu
Introduction
In the Settings menu there are two func-
tions: The function To reset, press reset
button for 3 seconds, with which you can
reset all the settings to the original factory
settings and a collection of submenus with
which you can make individual settings for
your vehicle.
The following settings and submenus are
available in the Settings menu:
R Resetting to factory settings ( Y page 135)
R Submenus in the Settings menu
(
Y page 136)
R Instrument cluster submenu ( Y page 136)
R Lighting submenu ( Y page 138)
R Vehicle submenu ( Y page 140)
R Convenience submenu ( Y page 140)
Resetting to factory settings
You can reset the functions of all submenus
to the factory settings.
For safety reasons, the function Light Cir-
cuit Headlamp Mode in the Lighting sub-
menu cannot be reset while driving.
X Press button è or ÿ repeatedly until
the Settings menu appears in the multi-
function display.
X Press the reset button in the instrument
cluster for approximately 3 seconds.
The request to press the reset button once
more to confirm appears in the right multi-
function display.
Controls in detail
Z