Mercedes-Benz G-Class 2007 Owners Manual - Manual (Page 376)

375
Practical hints
Brush guard
̄
Brush guard
The brush guard is available on G 55 AMG
(U.S vehicles only).
Lowering and raising brush guard
1 Locking and unlocking handle
2 Quick lock
3 Lock
4 End stop joint
Lowering
̈ While holding brush guard firmly, open
quick lock
2 using locking and unlock-
ing handle 1.
̈ Gently lower brush guard until it
reaches its fully lowered position.
Raising and securing
̈ Flip up brush guard until it contacts end
stop joint
4.
Quick lock stop pin 2 must engage
the cross slot recess in lock 3.
̈ Now turn quick lock 2 so that quick
lock makes contact with end stop
joint
4.
̈ Lock quick lock 2 on both sides of
brush guard using locking and unlock-
ing handle
1.
Warning!
G
The brush guard is designed solely to
enhance the appearance of the vehicle and
help protect grille and headlights from minor
mishaps, either on- or off-road. Since the
safety characteristics are limited in the
event of an accident, brush guards are not
intended to prevent injury or damage in the
event of an accident. Also check state and
local regulations on installation and use.
Raise and lower brush guard in an open
space with plenty of room.
To help prevent personal injury when open-
ing or closing the brush guard, use extreme
caution not to trap hands or feet.
The brush guard must be in raised and
locked position while driving.
i
Only lower brush guard to clean headlamps
or to replace bulbs.
! Make sure both quick stop pins 2 are
seated fully in lock 3.