Power Plate pro6 plus - Manual (Page 10)

WARNING: THE MACHINE
CONTAINS NO USER-SERVICEABLE
PARTS. PLEASE CONTACT AN
AUTHORIZED POWER PLATE
®
SERVICE PROFESSIONAL
FOR ANY MAINTENANCE OR
TROUBLESHOOTING NOT
OTHERWISE DESCRIBED BELOW,
OR PERSONAL INJURY OR DAMAGE
TO THE MACHINE COULD RESULT.
CAUTION: Any changes, modifications
or unauthorized maintenance performed
to or on the machine could void the
product warranty.
Always unplug the machine and then
wait for at least one minute before
performing any maintenance.
Clean the machine only with a moist
cloth. Do not use sharp objects, bristles,
scrubs or acid-based detergents, which
will damage the lacquer finish.
Do not spray any cleaning solution
directly onto the machine. Instead,
moisten a cloth, then apply to the
machine.
On plastic components, use only
polishes specifically designed for
plastic. Use a soft brush, not a cloth,
to clean the platform, including the
contoured mat.
Clean electrical components only with
a dry cloth, in order to avoid the risk of
shock or damage to the components.
Troubleshooting
Always unplug the machine and then
wait for at least one minute before
performing any troubleshooting.
If the machine is not operational and the
console display is not illuminated, check
the power connections to the machine.
If all power connections are working,
please check the circuit breaker or fuse
for the electrical outlet that is supplying
power to the machine in order to ensure
that the outlet is receiving electrical power.
If the console display is illuminated, but
the platform will not vibrate, unplug the
machine, wait at least one minute, then
check the connection to the machine’s
motor, located under the base of
the machine.
If the machine makes a rattling noise,
unplug the machine, wait at least one
minute, then check to make sure that
the feet are properly tightened.
DANGER: The user should not try to
resolve any electrical issues regarding
the power source to the machine.
Instead, Power Plate requests the
user contact a licensed, professional
electrician to conduct any examination
and make any necessary repairs.
Otherwise, serious personal injury
or property damage could result.
No modification for this equipment is
allowed.
APPLIED PARTS: Applied parts are not
intended to deliver heat during normal
use. The maximum temperature for
applied parts may be up to 43degrees
Celsius / 109.4 degree Fahrenheit.
!
!
•
•
•
•
•
•
•
•
•
•
!
Maintenance
Applied Parts:
• Platform
• Handlebars
Power On / Off :
• To Power On the Machine: Press the
rocker switch located on lower back of
the column to indicate “I” position.
• To Power Off the Machine: Press the
rocker switch located on lower back of
the column to indicate “0” position.
• To Power Off the Main Control Panel:
While power to the machine is on, press
and hold the green power button located
on the lower half of the main control
panel. This will power off only the main
control panel for standby mode. Press
and hold the green power button again
to power on the main control panel.
8 of 22