Rice Lake 880 Performance Series Indicator/Controller Operators Manual - Manual (Page 12)

Introduction 8
8. Press to return to
CFG
.
9. Press to return to the weigh mode.
1.4.10 Setpoints
Setpoints must be enabled in the setup mode to be accessible in the user setup mode.
To enter the setup mode:
1. Remove the large fillister head screw from the back of the enclosure.
2. Insert a nonconductive tool into the access hole and press the setup switch.
Indicator display changes to show
SCALE
.
3. Press or until
SETPTS
is displayed.
4. Press ,
SP CFG
is displayed.
5. Press , press or to desired setpoint number.
6. Press to enter setpoint settings.
7. Select the type by pressing or to desired setting, then press to set the
value. For complete list of options see Section 3.2.13.
8. When all settings have been made, press to return to weighing
mode.
Setpoints are now accessible from the front panel menu.
Display or Edit Setpoint Value
1. Press .
AUDIT
is displayed.
2. Press or until
SETPTS
is displayed.
3. Press and the first available setpoint number is displayed.
4. Press or to toggle through each setpoint that is operator accessible.
5. Press ,
is displayed.
6. Press again to display or edit the value. To edit the value:
• Press or to increment or decrement the value of the flashing digit.
• Press or to select the digit to edit.
• Press to move to the decimal point entry.
• Press or to adjust the decimal point placement.
7. Press to accept the displayed value.
8. Repeat the above steps to set
PREACT
, if enabled
9. When all settings have been made, press to return to weighing
mode.
Setpoint Value and Preact Value may be accessible from the front panel
in weigh mode.
Some indicator configurations may not allow setpoint values to be
changed through the front panel or may require a password to display or
change the setpoint value.
MENU
MENU
MENU
Note
MENU
TARE
TARE
MENU
Note