Rice Lake 880 Performance Series Indicator/Controller Operators Manual - Manual (Page 16)

Configuration 12
2.1.2 EDP Command Configuration
The EDP command set can be used to configure the 880 indicator using either a
personal computer or terminal. Like Revolution, EDP command configuration sends
commands to the indicator EDP port; unlike Revolution, EDP commands can be sent
using any external device capable of sending ASCII characters over a serial
connection.
EDP commands duplicate the functions available using the indicator front panel and
provide some functions not otherwise available. EDP commands can be used to
simulate pressing front panel keys, to configure the indicator, or to dump lists of
parameter settings. See the Technical Service manual for more information about
using the EDP command set.
2.1.3 Front Panel Configuration
The 880 indicator can be configured using a series of menus accessed through the
indicator front panel when the indicator is in setup mode. Table 2-1 summarizes the
functions of each of the main menus.
Figure 2-2. 880 Menu Layout
Menu Menu Function
AUDIT Audit Trail Displays the legally relevant (LR) firmware version,
configuration count and calibration count.
SETUP Setup
T&D Time and Date View and change time and date.
ACCUM Accumulator Displays the current accumulator value.
SETPTS Setpoints Configure setpoints.
TARE Tare Tare function. Enables or disables push-button and
keyed tare
Table 2-1. 880 Menu Summary
000000
000000
ACCUM
Displayed only
if turned on in
Scale Menu
AUDIT TARE SETPTS T & D ACCUM SETUP
000000
DATE TIME
No Access
unless the
jumper is
installed
VIEW CLR Y?
000000
See
Figure 2-7
See
Figure 2-6
See
Figure 2-18