Rice Lake 880 Performance Series Panel Mount Indicator/Controller - Analog Output Card Option Installation Manual - Manual (Page 3)

Analog Output Card
(PN 131601)
J8
Connector
Standoff
CPU Board
Option Card Screws
Analog Output Card Installation 3
Figure 4. Install Analog Output Board
11. Connect the CPU board and the power supply board to the new backplate.
12. Connect cable assembly to CPU boards and power supply board.
Power Supply Board
CPU Board
Assembly
New Backplate
(PN 156668)
Screws for connecting power
supply board to backplate
Screws for connecting CPU
board assembly to backplate
Cable, Power
to CPU
Figure 5. Install Boards to New Backplate
13. Slide backplate with boards into enclosure, ensure that each board is seated correctly in the grooves of the
enclosure.
14. Secure with retained corner screws.
Note
Ensure the enclosure is in the upright position, otherwise the connector for the display will not align with the
front cutcut. The DIN Rail clips will be at the bottom.
Ensure boards are seated properly
in the grooves of the enclosure.
Corner screws
DIN Rail Clip
Figure 6. Boards Installed in Controller Assembly Enclosure