Rice Lake 920i FlexWeigh Systems - 101 - Manual (Page 13)

Modifying the Setup Password 9
3.3 Modifying the Setup Password
Use the following steps to modify the setup password.
1. From the Main Setup Menu Screen , press the Setup Password softkey.
2. The system prompts, Enter New Password .
Figure 3-5. Enter New Password
3. Enter the new password and press the enter key.
4. The system prompts Re-enter password to verify.
5. Re-enter the password and press the enter key again. The system performs one of the following actions.
• If the passwords match, the system displays Password Changed.
• If the passwords do not match, the system displays Passwords Did Not Match and exits the operation.
3.4 Enabling/Disabling Additional Data Fields
Use the following steps to enable or disable additional data fields.
1. From the main setup menu screen, press the Setup Password softkey (shown in Figure 3-2).
A setup password is not required if it has never been set or if you are already in Setup mode.
2. Press the ID #1 or ID #2 softkey. The system displays Enable ID #1 or ID #2 while displaying Yes or No
softkeys or Disable ID #1 or #2 .
Figure 3-6. Enabling IDs
3. The operator does one of the following.
Press the Yes softkey, the system prompts Enter Extra Data #1 Name . Enter the name and press the enter key
on the 920i. A new data field appears on the main display and as a softkey so that the operator can change
it. To enter alpha characters, press the
Up navigation key to access a pop up alphabet.
Press the Yes softkey and this returns the operator back to Step 1.
04/27/2011 02:15PM SCALE #1
Cancel End
Enter New Password:
136.8 SCALE #1
Gross
Lb
Home
Program: Express 101 (V 1.00)
ID #1 (disabled)
Start O Zero Tol
ID #2 (disabled) Resume O Fill Copt
Dual Speed (enabled) Reset O Slow Fill
Auto Tare (enabled) Stop O Fast Fill
Auto Print (disabled)
Delay After Discharge (sec) :30
Note
04/27/2011 02:15PM SCALE #1
No
Enable ID #1:
=>
136.8 SCALE #1
Gross
Lb
SETUP MENU
Yes
Program: Express 101 (V 1.00)
ID #1 (disabled)
Start O Zero Tol
ID #2 (disabled) Resume O Fill Copt
Dual Speed (enabled) Reset O Slow Fill
Auto Tare (enabled) Stop O Fast Fill
Auto Print (disabled)
Delay After Discharge (sec) :30