Rice Lake 920i FlexWeigh Systems - 101 - Manual (Page 15)

Delay After Discharge 11
3.8 Delay After Discharge
Use the following steps to modify the delay after discharge.
1. Cycle through pressing the More => softkey to access the third setup menu screen which includes the Delay
After Discharge softkey.
Figure 3-10. Delay After Discharge Softkey Location
2. Press the Delay After Discharge softkey to access that softkey.
Figure 3-11. Enter Time
3. Enter in the time in seconds to delay after completion of a discharge before a new start input will be
allowed.
3.9 Test Digital IO
Press the Test Digital IO softkey to test the Zero Tolerance, Fill Complete, Slow Fill and Fast Fill relay outputs.
Figure 3-12. Test Digital I/O
Delay After
Discharge
04/27/2011 02:15PM SCALE #1
Cancel Home
Delay After Discharge (sec):
=> .30
136.8 SCALE #1
Gross
Lb
SETUP MENU
End
SETUP MENU
Program: Express 101 (V 1.00)
ID #1 (disabled) Start O Zero Tol
ID #2 (disabled) Resume O Fill Copt
Dual Speed (enabled) Reset O Slow Fill
Auto Tare (enabled) Stop O Fast Fill
Auto Print (disabled)
Delay After Discharge (sec) :30
04/27/2011 02:15PM SCALE #1
Fast Fill Exit
Setup Menu:
136.8 SCALE #1
Gross
Lb
SETUP MENU
Fill
Complete
Slow Fill
Program: Express 101 (V 1.00)
ID #1 (disabled)
Start O Zero Tol
ID #2 (disabled) Resume O Fill Copt
Dual Speed (enabled) Reset O Slow Fill
Auto Tare (enabled) Stop O Fast Fill
Auto Print (disabled)
Delay After Discharge (sec) :30