Rice Lake 920i Programmable HMI Indicator/Controller - WLAN User Manual
Wlan installation instructions, 920i, And 820i
October 2007
101995
920i
®
and 820i
®
WLAN Installation Instructions
Option PN 98057
NOTE: Before installing this option, you must contact your IT administrator to obtain network communication protocol
codes and have a RS-232 communications cable or regular comm port cable available to run between your PC and the
920i and 820i while installing and setting up the wireless network.
The 920i and 820i programmable HMI indicators offer an optional Lantronix
®
WiPort
™
(WLAN - Wireless Local
Area Network) wireless networking device which is installed inside the 920i and 820i indicator. This option can
be used for real-time data transmission to warehouse management systems. The Windows
®
-based configuration
software, DeviceInstaller
™
is required for installation and setup and is available on the CD that comes with the
kit. The WLAN option can be factory installed upon request when purchasing the 920i or 820i, or can be
purchased separately and installed on site.
The wireless LAN option comes in a kit containing the following items:
•
Pluggable wireless board (PN 97789)
•
Antenna (PN 98357)
•
CD containing Lantronix information (PN 72763)
•
This manual (PN 101995)
The following photo shows the WLAN card and antenna inside the 920i enclosure.
Figure 1. WLAN Board and Antenna Location Inside the 920i Enclosure
W L A N
b o a r d
l o c a t i o n
s h o w n i n
t h e 9 2 0 i
indicator
A n t e n n a
location