Rice Lake MSI4300 PortaWeigh Plus Crane Scale 5 Key User Manual

Page 21

Advertising
background image

M E A S U R E M E N T S Y S T E M S I N T E R N A T I O N A L

MSI-4300 Porta-Weigh Plus/5 Key

User Guide Page 21

register, and a tare register. Weighing setups can be prearranged by setting the
ID number and establishing a Tare Memory for that ID number. Then the next
time that particular ID number is selected the proper tare value is already
established, and any previously stored total value is enabled.

Action:
The ID number is changed by pushing “ID NUMBER” and then the desired
number (1-9). The default ID number is 1 which is the only available ID
without the remote.

Printing: Pushing the Print key on the remote will cause the current displayed
value to be printed (requires EIA-232 option).

Action:

To print the Gross, Net or Total values, first use the NET/GROSS key
or the VIEW

key to place the desired mode on the display, then push

PRINT.

To print the Tare value: While in NET mode push TARE followed by
PRINT.

Caution: Do not accidently push the Tare key while in Gross mode as this will
clear the old tare and establish a new tare.

Numeric Entry: The Tare memory values and Set-Point values can be directly
entered from the remote. Instead of using the select key to scroll through
values, push the desired number directly. The Tare memory number can also be
accessed directly. (i.e. SHIFT - TARE - 3 will directly select Tare memory
#3).

REMOTE CONTROL BATTERY REPLACEMENT

Type: Standard 9 volt (NEDA/ANSI 1604 A, IEC 6LR61). alkaline type is
preferred due to high LED peak currents. There is storage space for a spare
battery internal to the remote.

When to Change: The internal 9 volt battery needs replacing when the
indicator LED is no longer visible when any button is pushed. The operating
range of the remote will gradually decrease. When the range is insufficient for
your normal mode of operation, replace the battery (even if the LED is still
visible).

Installing/Changing:

1)

Turn the remote unit over. Remove the three phillips screws with a

Advertising