Available dip switch settings (parallel interface) – Rice Lake Star SP298 Series Programmers Manual User Manual
Page 7
4
Available DIP switch settings (Parallel Interface)
The following table shows all the possible settings for the DIP switch. The
factory default settings are ON for switches 1 through 7 and OFF for switch 8.
A reset can be performed with pin 31 on the interface by setting DIP switch 1 to
ON (the factory default setting).
In addition, when a reset can be performed with pin 31, setting DIP switch 2 to
OFF sets up the unit to perform a reset when pin 31 and pin 36 are “LOW”.
*1: Never set switch 7 to OFF at the same time that switch 8 is set to ON.
Switch
Parameter
ON
OFF
1
Pin 31 / Pin 36 Reset Signal
See table below.
2
3
Not used
(Always ON)
4
5
6
7
Command Emulation
See table below.
8
Reset Signal
Switch 1
Switch 2
Pin 31 is enabled.
ON
ON
Pin 31/Pin 36 are enabled.
ON
OFF
Disabled
OFF
ON
Disabled
OFF
OFF
Command Emulation
Switch 7
Switch 8
Star mode
ON
ON
ESC/POS (TM-295)
ON
OFF
ESC/POS (TM-290)
OFF
OFF
Not used (*1)
OFF
ON