3 cage assembly, 1 apply the silicone bead (mobile scales only), 2 install walls – Rice Lake Portable Group Animal Scale - MAS-P - Operators Manual User Manual
Page 14: Apply the silicone bead (mobile scales only), Install walls
3
MAS-P Animal Scale Operator’s Manual
2.3 Cage Assembly
2.3.1
Apply the silicone bead (Mobile scales only)
Before installing the walls a silicone bead must be added.
1. Clean the upper flange of the floor and the lower wall flange with mineral
spirits.
2. Apply an 1/8” bead of silicone along the upper edge of the floor panel along the
entire length as shown in Figure 2-4.
Silicone
Wall Insert
Figure 2-4. Silicon Bead
2.3.2
Install walls
WARNING
Wall installation should be done with 2 people or an overhead
crane.
1. Lift the first wall by using one sling in the center.
Note
Note
The wall with the operator’s instructions is mounted on the left side.
2. Stand the wall vertical and place the inserts from the wall into the tubes of the
cage floor. The more vertical the wall the easier assembly will be.
3. Repeat for the opposite wall.
4. Install the top cross members.
5. Insert the 3/4 x 3 1/2” bolts through the cage wall and inserts on the indicator
side of the cage, head of bolt to the inside.
A come-along from the top of the cross member to bottom of the cage
corner post may be required.
For 18 ft scales a 1/2 x 3” bolt and nylon locknut is installed on the center
post with the nut on the outside.