Rice Lake RoughDeck Rough-n-Ready System - Manual (Page 11)

Installation 7
2.7 Access Ramps
Access ramps for RoughDeck floor scales are designed to bolt to the floor, with built-in mounting plates that attach
to the scale feet. When used with access ramps, side movement of the scale is automatically eliminated, and no
other mounting plates are necessary.
Access ramps can only be attached to the scale on one of the two scale sides that are perpendicular to the
longitudinal axis of the load cells. For example, the scale shown in Figure 2-5 could have an access ramp on the left
side as shown, and/or on the right side. The top and bottom sides, will not accept the ramp mounting plates.
Longitudinal axis
of load cells
Figure 2-6. Optional Access Ramps
See Table 4-3 and Table 4-4 on page 12 for information about available access ramps.