Rice Lake SURVIVOR LaserLight Series Remote Display - ConnexLink Wireless Radio 900 MHZ Installation - Manual (Page 3)

ConnexLink Option Installation Instructions 3
6. Loosen the ground-screw nut with a 11/32 nut driver or socket wrench.
7. Remove the ground wire from the bottom panel.
8. Remove and discard plastic plug in bottom panel.
Ground wire
Plastic plug
Figure 4. Remove Ground Wire and Plastic Plug from Bottom Panel
Radio
Bracket
Screw and Nut
Figure 5. Assemble radio to bracket
9. Assemble the radio marked "Client" to the bracket using the screws and nuts included in kit.
To ensure that the correct radio is installed with the remote display and the indicator,
Note
each radio is marked
with either CLIENT and SERVER.
Client is to be installed with the remote display.
Server is to be installed with the indicator.